FEM analysis of 3D lattice structures of ABS material
Main Article Content
Abstract
FDM is a typical additive manufacturing method. Since FDM is a method of stacking layers one by one, it generally has a flat lattice structure. In this study, by checking the distribution of stress and deformation for several lattice structures made of ABS material, it is intended to find a structure with better mechanical properties with less material. Several three-dimensional lattice structures are modeled using parametric modeling. Subsequently, a constant pressure is applied to the same area to check the stress and strain distribution. A structure with a low maximum stress value in the stress concentration region and a small amount of deformation will have the best mechanical properties. To do this, parametric modeling is performed using Inventor to model four three-dimensional lattice structures. Afterwards, use Ansys Workbench to check the stress and deformation distribution. Looking at the stress distribution, stress concentration occurred in the truss supporting the upper surface of the SC structure. In the BCC and PTC structures, stress concentration occurred at the point where the upper surface and the truss met. In the FCC structure, it can be seen that the load is distributed throughout the truss structure. Looking at the deformation distribution, both the SC and BCC structures show similar amounts of deformation. It was confirmed that the FCC structure had less maximum deformation than the PTC structure with the thickest truss. Unlike previous studies, it was confirmed that the higher the internal filling rate, the better the mechanical properties may not come out. The FDM method can obtain different mechanical properties depending on the internal lattice structure as well as the internal filling rate. In a later study, we will find a new calculation algorithm that applies variables by FDM characteristics using the data obtained by printing the actual specimen.
Downloads
Metrics
Article Details
Licensing
TURCOMAT publishes articles under the Creative Commons Attribution 4.0 International License (CC BY 4.0). This licensing allows for any use of the work, provided the original author(s) and source are credited, thereby facilitating the free exchange and use of research for the advancement of knowledge.
Detailed Licensing Terms
Attribution (BY): Users must give appropriate credit, provide a link to the license, and indicate if changes were made. Users may do so in any reasonable manner, but not in any way that suggests the licensor endorses them or their use.
No Additional Restrictions: Users may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.